When edge gluing boards, I use scrap blocks to distribute the clamping pressure and avoid marring the edges. But sometimes the blocks shift out of position or fall to the floor before I get the clamps tightened. To solve this problem, I made a number of U-shaped clamp blocks that slip over the edge and stay right where I put them.
A great small jig for edge banding plywood with solid wood strips.
In the past, I used to just clamp a board to my drill press table whenever I needed a fence. But trying to position the fence was awkward. So I came up with a fence design08 that is easier to use and incorporates a stop block.