Build this small parts vise for the workshop made out of plywood and a few clamps.
Here is a quick video on building a pipe clamp rack.
This is a link to a Google 3D SketchUp drawing for a clamp storage rack. You will need the SketchUp software to download this drawing and its freely available online.
This is a link to a Google 3D SketchUp drawing for a corner clamp setup which effectively places good clamping across mitered corner joints and is shop made from scraps and 2 strips of sandpaper. You will need the SketchUp software to download this drawing and its freely available online.
This is a link to a Google 3D SketchUp drawing for my bar clamp storage system. You will need the SketchUp software to download this drawing and its freely available online. We do not provide support for this software.
If you do not have a dedicated veneer press, you can still get the job done with common clamps, cauls, and wooden beams, as long as you use enough clamps for adequate pressure and distribute the clamping pressure as evenly as possible.
I got tired of finding my band clamps all balled up in a drawer, so I devised these ultra-simple holders to keep them in order.
This drill press vice will help make precise items by the measurements given on particular 2D drawings. The measurements are given in millimeters, and the measurements in inches are given in brackets.
When gluing and clamping small parts together, it is always a challenge to align large clamps to hold them in place as the glue dries. To make this job easier, I built the small parts clamp you see in the photo.
Occasionally, I will need to sand a small wooden part on a drum or disk sander. But holding onto small parts can be a challenge. A pair of pliers could do the job, but I wanted something with a softer grip. So I came up with the small parts clamp shown in the photo.